If you’re a music lover, you must know the value of enjoying good music played with good sound quality. In order to achieve the best sound quality, a professional audio system set up by A/V Company services is usually required. However, with the knowledge of the gadgets and the right hacks, you can get the desired output from your music device.
Ardent music fans understand the importance of a subwoofer setting (like Wiring 2 Subs to Mono Amp) in getting the most out of any sound system. Most modern subwoofers include an amp. You might, however, possess a subwoofer and a vintage amplifier that you’d like to hook up to a speaker. The best method is to use RCA jack outputs on your vintage amp to connect it to your subsystems and speaker. There are also these superb bookshelf speakers which are incredibly tech-savvy, made for high definition sound quality and built with the benefits of both Bluetooth and WiFi speakers.
The amp and subwoofer you’re using will influence which port you use. Although setting up appears to be simple, there are some intricacies to consider. This post will show you how to hook up a subwoofer to a vintage amplifier.
General Methods for Connecting a Subwoofer to a Vintage Amplifier:
The following steps are involved in connecting a subwoofer to a vintage amplifier:
- Passive subwoofers require an additional amplifier to interface with other output/input systems. You’ll need RCA connections to hook the amplifier to the subwoofer and your speakers if you want to use it with different systems. It is worth mentioning that if the receiver includes an RCA jack, the subwoofer will play without an auxiliary amplifier.
- Yellow, white, and red connectors make up an RCA cable set. When placing your subwoofer in a room, assess the accessibility and connections of input/outputs and the sound direction. Before rigging it to your other systems, make sure your subwoofer and amplifier are turned off and disconnected from any power source. You can also consider wiring 2 subs to a mono amp for best bass output.
- Thereafter, you may plug the RCA cables from your receiver to the woofer. While one set of RCA wires would suffice, two sets will produce a richer and deeper audio experience. On most amps, the RCA jack is labeled “subwoofer output.”
- Next, ensure the receiver’s input port is connected to the subwoofer’s output port. Connect your receiver to the speaker system once these are configured. The speaker connections of an amplifier are usually found on the rear panel. Each speaker output must be relayed via speaker cables.
- The right-hand output wire should be connected to the right-hand speaker, and the left-hand output wire should be connected to the left-hand speaker. You need to plug the positive and negative leads of the speakers to the correct places on the receiver if you own receivers with designated positive and negative terminals. Once you are finished, reconnect the amplifier and subwoofer to a power source and switch them on.
Final Thoughts:
When you plug your vintage amplifier into your subwoofer, the signals are received at approximately similar frequencies regarding tonal balance and damping.
You should now be able to install your sound system after learning how to plug a subwoofer into a vintage amplifier. Some people find the sound quality of vintage amplifiers nostalgic, and it’s understandable why you’d want to power up a vintage system, especially if you are searching for a distinctive sound.